Posted by Circuits Arena on Wednesday, 11 May 2016
Electronic Mosquito Repellent Periodically ‘ON’ and ‘OFF’ by Using IC 555 is the artlcle explaining Electronic Mosquito Repellent Electronic Mosquito Repellent Periodically ‘ON’ and ‘OFF’ by Using IC 555 The circuit turns the Ele...
Electronic Mosquito Repellent
Electronic Mosquito Repellent Periodically ‘ON’ and ‘OFF’ by Using IC 555
The circuit turns the Electronic mosquito repellent periodically ‘on’ and ‘off’ for approximately 20 minutes each. So if you leave the mosquito repellent switched on from 10 pm to 6 am (eight hours), it will be ‘on’ for four hours and ‘off’ for four hours of the total duration. During ‘off’ time, the room air tries to balance its natural composition. Another important feature is that the circuit switches to ‘on’/‘off’ operation without producing any noise or a sound click as in a relay and hence doesn’t disturb your sleep.
The circuit consists of a timer section built around IC 555 (IC1) and an automatic switching section using Triac BT136 (TRIAC1). Power supply to the circuit is derived from the AC mains by stepping it down to a required level and rectifying it. The elimination of the transformer saves on space as well as money. Zener diode ZD1 and capacitor C2 provide regulated 9V DC power supply to timer IC1.
The timer section comprises resistors R1 and R2 and capacitor C1. The output of timer IC 555 is fed to the gate terminal of BT136 through series LED1 and resistor R4. When the timer output goes high, it triggers the gate of TRIAC1 and LED1 shows the ‘on’ period. During ‘off’ time, the output of IC1 goes low and hence TRIAC1 is not fired and LED1 doesn’t glow.
Read Also:
ELECTRIC FENCE CHARGER CIRCUIT BY USING IC NE555
The
circuit is very compact and can be assembled on a general-purpose PCB. Use an 8-pin IC base for timer IC LM555. After assembly, fit the unit inside the housing electric board where you plug in the mosquito repellent.
